Archive for the ‘Start’ Category
How to clean or disassemble brushless motor
Posted: 30th July 2015 by viljem_r in Quadcopter, Start, Technical stuffTags: 1100kv, brushless motor, quadcopter, r/c, turnigy
VP44 Bosch pump electronic module repair , Opel 2.0 dti (x20dtl,y20dtl)
Posted: 18th May 2015 by viljem_r in Cars,bikes, vehicles, Garage, StartTags: bosch, bosch pump, dti, edc, vp44, vp44 repair
A lot of opel diesels have problems with Bosch vp44 fuel pumps. Pumps electronic module is crap. It can happen to you that engine will suddenly not start. You can’t just buy it and replace it, you need to rebuild the pump and that costs a lot. So you can to repair electronic module. It […]
Testing Fpv quanum set from hobbyking
Posted: 14th May 2015 by viljem_r in Quadcopter, StartTags: drone, fpv, gopro, hobbyking, quadcopter, quanum set fpv
Here I’m flying fpv with quanum set and Gopro hero 3 black instead off camera in set. Video is shaky and has a lot off jello effect, because I used frame instad off gopro housing. If you are recording while using camera for fpv there is some lag, but you still can fly without any […]
Unscrewing rusty nut on rear axle on your atv
Posted: 13th April 2015 by viljem_r in Garage, StartTags: atv, nut, quad, rear axle, rust
Here is how can you unscrew rusty nut on rear axle.
Tbs clone 450 alu frame with dji naza
Posted: 26th March 2015 by viljem_r in StartTags: dji naza, drone, movie, quadcopter, tbs
Mini quad with naze32 and fpv, video
Posted: 2nd March 2015 by viljem_r in Quadcopter, StartTags: fpv, mini quad, naze32, racer
Video of testing mini quad-racer for 80 eur with fpv from hobbyking. We used naze 32 controller. It was very windy, but it flew nicely.
Hobbyking HK6S receiver mod 3 position switch for dji naza
Posted: 14th February 2015 by viljem_r in Quadcopter, StartTags: DIY, dji, dji naza, hk6s, naza, quadcopter
Here is video about mod you will need if you are flying with dji naza. You will 3 positions on chanel 6 to select flight modes. Original potentiometer is not good, because it switches modes and it is really hard to select mode. Original has 10k potentiometer. So voltage is 3,3V between brown and orange wire. […]