VRCustoms

CVT clutch was in bad shape on my ATV sym quadlander. New costs a lot of money, so I rebuild it.

First you need to dissasemblly cvt and take down clutch.

As you can see it was in really worn.

First you need hot gun or torch to heat that big nut. Nut is secured with screw glue. You won’t loosen it without propper amount of heat! Loose it carefull, because under it is big spring. Wear protection glows and face shield.

They use special tools for that.  I didn’t, because it is not so strong.

Then remove all 3 springs with screw driver and then rings.

Took it to company which rebuild clutches and brakes.

Then asembled together. You must check that big spring. If it si too soft you need to replace it! Put some grease, make sure it is heat proof. 

I had to replace clucth bell ,because it was over heated.

At the end make sure you put some screw glue on nut;)